Search found 4 matches

by grahams
17 Apr 2011, 19:14
Forum: GHD MS
Topic: MS Temperature
Replies: 1
Views: 4075

MS Temperature

Hi Gary, I just replaced both heating elements in MK3 mini styler however what is the normal operating temperature of these irons? I adjusted the temp on the pcb but must have gone too far and they cut out. When they cooled they came back on. My temp probe measured around 150c. They are also quite s...
by grahams
15 Oct 2010, 09:22
Forum: GHD 3.1B
Topic: Straighteners not on
Replies: 5
Views: 5557

Re: Straighteners not on

Hi Gary, Pleased to say that after changing the thermal fuse they started working again. I just have a final couple of questions. The thermal fuse which i received is longer than the original and therefor doesn't fit properly behind the backing plate. I had to leave out the metal retaining clip in o...
by grahams
09 Oct 2010, 17:17
Forum: GHD 3.1B
Topic: Straighteners not on
Replies: 5
Views: 5557

Re: Straighteners not on

Hi Gary,

Thanks for your reply. Yes I replaced them with the 160ohm.
by grahams
08 Oct 2010, 17:01
Forum: GHD 3.1B
Topic: Straighteners not on
Replies: 5
Views: 5557

Straighteners not on

Hi, My first attempt to repair my wife's 3.1b's. Led was coming on and going off. I replaced the cable. They came on but went off again. When squeezed together light would come on. Checked website and followed instructions. Sure enough heater wire just came away. Ordered new heater elements, install...

Go to advanced search