Page 1 of 1

Thermal fuse blown again

Posted: 26 Oct 2017, 15:54
by redfred
Hi, I fitted a new thermal fuse and thought great job done. Unfortunately not, switched on fine, bleep and they heated up but got too hot. Could smell them then the fuse went pop again. Both plates are showing about 65 ohms connected. What could be causing this? Thanks

Re: Thermal fuse blown again

Posted: 22 Nov 2017, 22:57
by Webinfusion
Thermistor faulty or come unatached if both heaters are good.

Re: Thermal fuse blown again

Posted: 23 Apr 2018, 11:30
by Mcelligott
I've had this happen a couple of times as well. What do you suggest I do if the thermistor is faulty, Webinfusion? Am I screwed in that case?

Re: Thermal fuse blown again

Posted: 23 Apr 2018, 11:45
by gary
You either need to reattach the thermistor with some high temperature glue, or replace the heater element.

This is the heater element with thermistor attached:
http://www.ghd-repair.co.uk/shop/new_70 ... thermistor

Gary