Thermal fuse blown again

Posts: 1
Joined: 26 Oct 2017, 15:48

Thermal fuse blown again

Postby redfred » 26 Oct 2017, 15:54

Hi, I fitted a new thermal fuse and thought great job done. Unfortunately not, switched on fine, bleep and they heated up but got too hot. Could smell them then the fuse went pop again. Both plates are showing about 65 ohms connected. What could be causing this? Thanks

Posts: 134
Joined: 20 Jan 2012, 02:13

Re: Thermal fuse blown again

Postby Webinfusion » 22 Nov 2017, 22:57

Thermistor faulty or come unatached if both heaters are good.

Posts: 1
Joined: 16 Apr 2018, 10:29

Re: Thermal fuse blown again

Postby Mcelligott » 23 Apr 2018, 11:30

I've had this happen a couple of times as well. What do you suggest I do if the thermistor is faulty, Webinfusion? Am I screwed in that case?

Site Admin
Posts: 1032
Joined: 26 Jan 2008, 00:44

Re: Thermal fuse blown again

Postby gary » 23 Apr 2018, 11:45

You either need to reattach the thermistor with some high temperature glue, or replace the heater element.

This is the heater element with thermistor attached: ... thermistor


Return to “GHD 4.2B”

Who is online

Users browsing this forum: No registered users and 4 guests