MS Temperature

grahams
Posts: 4
Joined: 08 Oct 2010, 16:55

MS Temperature

Postby grahams » 17 Apr 2011, 19:14

Hi Gary,

I just replaced both heating elements in MK3 mini styler however what is the normal operating temperature of these irons? I adjusted the temp on the pcb but must have gone too far and they cut out. When they cooled they came back on. My temp probe measured around 150c. They are also quite slow in coming up to temperature.

Many thanks.

gary
Site Admin
Posts: 1032
Joined: 26 Jan 2008, 00:44

Re: MS Temperature

Postby gary » 19 Apr 2011, 10:41

Hi,

They normally run at about 180degC when you clamp a thermocouple between the plates. Obviously a different style of probe will give a different temperature reading. You have to adjust the temperature very gradually as if you make them too warm and then reduce the setpoint, then they will cut out and wait until they cool down naturally.

Gary


Return to “GHD MS”

Who is online

Users browsing this forum: No registered users and 1 guest